Smart Array P410 for Unraid

Manage HP Smart Array controllers (P410 / P410i / P212 / P812 and related G6/G7 models) directly from the Unraid web UI, without rebooting into the Option ROM.

Features

• Status: controller, firmware, cache and battery/capacitor state.

• Drive map: bay → physical drive → logical drive (LD) → /dev/sdX → Unraid slot, with model, serial, temperature and LD cache state.

• SMART through the controller (smartctl -d cciss,N), with the correct index found automatically by serial number.

• Locate LED on/off per drive.

• Create RAID0 LD from an unassigned drive (P410 has no HBA mode, so every disk needs its own RAID0 volume).

• Delete LD: you must type the LD number, and it is refused while the device is assigned in Unraid or mounted.

• Enable LD cache (only offered when the controller cache is working).

• Periodic monitoring: controller, LDs and SMART for all drives. The following are reported as problems:

  • any status other than OK,
  • pending or uncorrectable sectors,
  • growth of reallocated sectors, grown defects or uncorrected errors since the baseline,
  • temperature above the threshold.

  Failed-battery and disabled-cache warnings can be ignored until you replace the battery.

• Unraid notifications when problems appear and when they clear.

• MQTT + Home Assistant discovery. Built-in MQTT client, so nothing extra is needed on Unraid. Topics:

  • unraid/p410/state (JSON summary),
  • unraid/p410/problem (ON/OFF),
  • unraid/p410/bay/N (per bay),
  • unraid/p410/alert (new problems only).

• Dashboard tile (Unraid 6.12+).

• Languages: English (default) and Polish, chosen automatically or manually.

Installation

Plugins → Install Plugin and paste:

https://raw.githubusercontent.com/francuz152/unraid-p410mgr/main/p410mgr.plg

The page is under Settings → User Utilities → Smart Array P410.

During installation the plugin downloads hpssacli-2.40-13.0_amd64.deb from the official HPE Software Delivery Repository and caches it on the flash drive, so later boots work offline. hpssacli is HPE software and is subject to the HPE license; it is not distributed with this plugin.

Notes

• Tested on a Smart Array P410 (firmware 6.64) in an HP StorageWorks P4500 G2 / DL180 G6 chassis.
• Unraid counts every logical drive as an attached device for licensing.
• Uninstalling keeps your settings in /boot/config/plugins/p410mgr/. Delete that folder for a full removal.
• Building from source: python3 build.py assembles src/ into p410mgr.plg.

Polski

Plugin do zarządzania kontrolerami HP Smart Array (P410 i pokrewnymi) z poziomu GUI Unraida:

• stan kontrolera, mapowanie kieszeń → wolumen → /dev → slot Unraida, SMART przez cciss, dioda lokalizacyjna,
• tworzenie i usuwanie wolumenów RAID0 bez restartu,
• cykliczne sprawdzanie z powiadomieniami, MQTT z autodiscovery dla Home Assistanta, kafelek na Dashboard.

Interfejs jest dostępny po polsku: ustaw Język → Polski albo zostaw Automatyczny, jeśli Unraid ma polską wersję językową.

License

MIT. See LICENSE. HPE hpssacli is not covered by this license.